storing gear in syringes

[twistedneck]

If i pre load a syringe with QV test prop and Zambons, what precautions can be taken to make sure it stays clean? (just for a few days).. Will b12 be ok in there too?

TW

[Bigbadasian]

|---[\\\\]>--------- Away from heat and light. cool dark place it'll stay clean. you can mix anything you want just as long as they are all sterile.

[kronah]

Just a reminder to make sure to use everything that you loaded in the syringe. Once you inject and aspirate both needle and syringe part are no longer sterile so you cannot just load everything in the syringe and shoot half of it one day and the other half the next day . Perfectly fine to store any mix want you want in the syringe but only use it once then throw it away. Hate to see you get an abscess.

[twistedneck]

Bigbadasian and Kronah. Cool.. you guys andsered my questions exactly. I was worried about gear ozzin' out the needle end and getting contaminated by the pin cover too, but if cover is new than its all sterile. store pin down, up or does it even matter. thanks TW

[kronah]

Doesn't matter, I just place mine laying flat. The inside of the needle cover is sterile so you are fine either way. Just a word of advice if you decide to preload your winny make sure before injecting it that you switch it and shake it. If you don't you will take the chance of the powder clogging the head of the pin and you won't be able to inject it. I learned this the hard way. Good luck bro.

[hugemuscles10]

kronah I did the same thing with the winny, I was pushing on that sucker for all its worth and couldn't budge it. Made my arm hurt like hell.

[Bigbadasian]

|---[\\\\\]>----------- If you want to ensure that nothing leaks out of the needle, make sure you pull back on the plunger b4 you put the cap back on, taht way there is an air pocket in they syringe.

[HellaYella]

if u want to pre-load syringes do it, but don't keep them for over a month as the BA in alot of the MEX or UG products will eat up the rubber plunger and u end up with juice spilling out the other end as u inject...

[mike man]

Don't store those 2 items in the freezer for the long haul. I did that before with prop and it crystalized on me. It was for about 6 months (although I don't think it would matte once it froze).
I had to empty out all the syringes into a sterile bottle and then heat it up until the crystals desolved and then filter the whole bunch into another sterile bottle.

[joedokes]

I've had winny clog up a needle before, after just a few hours. I would suggest pointing upward so that doesn't happen. Depends on the winny too.