Question on certain kit...

[akursus]

I just used a 6g kit from researchkits. Worked fine but prolly won't use them again as I didn't like the fact that the vial containing the oil was crimped which made it a little difficult to pour the dissolved pellets into the oil (guess I coulda removed the crimp). I am just used to Animal's kits. Kaotik will be next -/.

Anyway... here's my question... The 6g kit came with a 50ml vial... If I remember correctly, so does a 4g right? So... with my 3 carts does that make a higher MG per ML ratio because of still only producing 50ml? I guess I just expected more volume with a 6g kit. I remember making close to 50ml with a 4g kit many times. With this 6g I came in just under filling the vial to the max... so prolly around 53 ml or so.

Not too crucial as I go ED anyway regardless, just would like to know the ballpark figure of my ratio...

Ursus...

[rAJJIN]

i dont know if i understand your question but a 6g "Fkit"
should produce appx 60-65ml @ 75mg.
i used research kit bro and it sucked ass. my shit turned out red
and settled to the bottom not to mention the PAIN. recently used Kaoitik and ill say
if you like(ed) Animals service and F kit, you will be very happy with KC`s. Almost identical, rubber pop out stoppers an all.
even threw in xtra vial for my filter process.
and hes very easy to get along with. goodluck bro
an good seing you on the board/.
rAJJIN

[rAJJIN]

ok i read it again and your correct.
less oil = higher mg. Id say yours is closer to 85 0r 90 (just a guess) that should be up to the guy making it to use less though
cant beleive hed short ya on oil lol.

[akursus]

Next time I will use Kaotik no doubt. My final product turned out crystal clear and straw gold (semi cloudy after 24 hrs however... always is as I don't use the coffee filter). I had no difficulties getting a product that is appealing to my cows it was just a bit disconcerting as I had to improvise as I went along. The rubber stopper is definitely the preferred method. I am pretty positive that both the sterile vial and the oil vial are 50's (I've gone through a few 50's of other gear... heh heh...) so here is my logic, please pipe in if you think it is flawed!

6000mg's of hormone
50ml of oil

6000/50= 120mg per ml

I actually think it was around 53ml so roughly 113.2mg per ml as I see it. I don't mind 100+ mg per ml stuff but I would rather have preferred a 4g and a 2g kit instead for a bit more volume and my usual 75mg per ml mixture.

Anyway... thanks for replying rAJJIN! Good to be back around!

Ursus...

[rAJJIN]

your math looks correct to me bro,lol
shit i always get one extra cart just in case any gets lost
during the crushing process. all i know is that it works good.
Kc will take care of you im sure that youll be happy.