got my pellets and kit ,but no instructions!help

[Ass Hole]

My pellets made it & my kit did too but ,no directions on how to do any of the conversion.I found some directions on some other sites but they all talk about vials with screw on caps my kit came from "FINAKITS.com" they have krimp ons .It has "I think" 100cc in one bottle another one same size empty and abottle with a screw on lid with a little bit of fluid in it .syringes,filters,pins...... I have a full box of pellets. Please help.

[Macdaddy]

This was taken from the Fittness board...


FINAPLIX IN THE KITCHEN
Inventory check. Make sure you have everything before you begin.
This example uses a 2,000mg amount, and makes 76mg/20ml
10cc syringe
3-5 cc syringe
Two needle tips
filter
3 vials, one with solution, one with oil, one empty (sterile) vial
Funnel
Coffee filter or paper filter
Alcohol or alcohol wipes
Gloves (plastic bags)
Below is what the items needed should look like

--------------------------------------------------------------------------------

STEP 1

Crush pellets with an alcohol wiped spoon, in a alcohol wiped dish, jar, glass etc. Crush them finely. The finer the pellets are crushed, the less time they take to dissolve in the solution.


--------------------------------------------------------------------------------

STEP 2

Put a funnel into the vial with lesser amount solution, (clear solution), and pour the crushed pellets down the alcohol wiped funnel.


--------------------------------------------------------------------------------

STEP 3

Let the solution sit, swirling it once every minute, until the pellets have completely dissolved. (depending on how well you crushed the pellets, this could take from 20min – 12 hours)


--------------------------------------------------------------------------------

STEP 4

While the pellets are dissolving, get out a 3 to 5 CC syringe, and draw up 2 – 3 CC’s of oil and recap the syringe and put it away. You will need this (2cc’s) for one of the last steps in this process. (Note: get two cc’s from the oil vial, darker solution, not the vial with the dissolving pellets, but from the unused oil vial)

--------------------------------------------------------------------------------

STEP 5

Once the pellets are COMPLETELY dissolved, pour the oil from the vial you drew out 2cc’s oil into the vial with now dissolved pellets. (Add oil from oil vial to dissolving pellets solution/pellets vial)


Swirl the oil/solution/dissolved pellets mixture for 5 – 15 minutes or until it is completely MIXED.

--------------------------------------------------------------------------------

STEP 6

Get the now emptied oil vial (the one you used to pour oil into the pellet/solution vial) and place the funnel into it, then, place the opened coffee filter into the funnel.


--------------------------------------------------------------------------------

STEP 7

Then pour the oil/pellets/solution that has now mixed well, down into the coffee filter slowly. Let it sit over night and drip into the vial.


--------------------------------------------------------------------------------

STEP 8

In the morning. Gently squeeze out any remaining oil in the filter and let it drip down the funnel. then remove the filter and funnel.


--------------------------------------------------------------------------------

This is a picture of the coffe filter. discard all of the gunk the filter caught.


--------------------------------------------------------------------------------

STEP 9

Wipe top of the empty (so far unused, sterile vial) vial with alcohol, and insert a needle tip to release pressure when adding the final product.


--------------------------------------------------------------------------------

STEP 10

Use at least a ten CC syringe and draw out ‘oil/pellet/solution’ mix into the syringe.


--------------------------------------------------------------------------------

STEP 11

Remove the needle tip. Place a filter and needle tip on the filled syringe, and filter the syringe contents into the sterile vial. Continue this step until all the ‘mixed solution’ is into the sterile vial.


--------------------------------------------------------------------------------

STEP 12

Then, put the filter on the needle with the saved

[Macdaddy]

You need to take the cap off of the solution vial. Its the only way to get the pellets in.

Macdaddy

[Big Hock]

Kitchen Chemist

Thats a good link for making your fina.


mooo

-Big Hock

[basskiller]

Converting fina ....with pictures