25 5/8 pins, will these be ok for delt and quad shots?

fitnessbuff · #1 (**permalink**) 09-23-2002, 07:06 PM

hi, i guess i wasnt paying attention when i was ordering my plungers and pins. I accidentally ordered a good amount of these size pins, 25 5/8....... would these be ok to use for the delts and quads? thanks... :help:

MikeS · #2 (**permalink**) 09-23-2002, 08:10 PM

Alot of guys may say no-but theyre fine to me!
Less scar tissue also.
Unless you have high bodyfat.

rj420 · #3 (**permalink**) 09-23-2002, 08:11 PM

delts if you are lean, probably would not hit the quads. If thats you in the pic, then you are probably good to go with the delt injects. Inject slow though, and leave the needle in for a couple extra seconds. Otherwise some oil may come back out when you withdraw the needle. Could hit some site injects too.

fitnessbuff · #4 (**permalink**) 09-23-2002, 08:15 PM

ya, that is me....i think ill use it for delts. Thanks guys. U rock/;

simon birch · #5 (**permalink**) 09-24-2002, 02:08 AM

depends on your BF % but there fine.later

preist943 · #6 (**permalink**) 09-24-2002, 02:59 AM

i use the same size for delts bis and tris your good to go bro

fitnessbuff · #7 (**permalink**) 09-24-2002, 04:08 AM

thanks guys
/t\

Bigbadasian · #8 (**permalink**) 09-24-2002, 06:17 AM

|--[\\\\]>------- It doesn't matter what gauge you use, just the length. You want to go DEEP into the muscle...using a smaller guage will allow less scar tissue.