what size syringe

[Daveb19]

Yea what size needles do u all reccomend for test and fina cycle, guage/length???

[Statix]

i just use 22 gauge 1 and 1/2 inch all the way around...you would be fine with 23 or 25 gauge and 1 inch everywhere, except i would stick with 1 and 1/2 inch in the glutes

[xcelbeyond]

Use a 20g or 18g to draw gear with. Suck a little air in syringe then replace the pin with a 25g (of course remove air before you poke). Use a 1" for everywhere (quads, delts, bis. tris) and a 1-1/2" for glutes (unless you're one of those skinny guys w/no arse).

You dull a needle poking through the septum in a vial. So, doing this will give you fresh pin for the poke. It takes a LONG time to draw gear through a 25g pin (very frustrating if you do). The 25g will make you inject SLOWER. You shouldn't be injecting faster than 1cc per minute. The 25g will help injections go slower and will cause less trauma at injection site.

xcelbeyond /t\

[preist943]

dead on xcel thats just what i do too

[excape]

Agree with xcel, 22g, 23g or 25g is good, 1in or 1 1/2in!

[Paul Bunyan]

I use 23ga 1" for glutes and 25ga 1" everywhere else. Why poke a bigger hole than necessary. Always use a draw pin so you don't dull the shooting pin. Makes the shots alot easier.
PB

[karnage]

I prefer 25 gauge 1 inch to inject.I use 18 gauge to draw up always.
I never have a problem pushing oils thru, just takes a bit longer.It's all preference.

[Daveb19]

thanks for the post guys, good info taken in