Fina pellets – to – Fina-ject by: willK
Inventory check. Make sure you have everything before you begin.
Pellets (2,000mg's make 76mg/20ml)
10cc
syringe
3-5 cc
syringe
Two
needle tips
filter
3 vials, one with solution, one with oil, one empty (sterile) vial
Funnel
Coffee
filter
Alcohol or alcohol wipes
Gloves (plastic bags)
Crush pellets with an alcohol wiped spoon, in a alcohol wiped dish, jar, glass etc. Crush them finely. The finer the pellets are crushed, the less time they take to dissolve in the solution.
Put a funnel into the vial with lesser amount solution, (clear solution), and pour the crushed pellets down the alcohol wiped funnel.
Let the solution sit, swirling it once every minute, until the pellets have completely dissolved. (depending on how well you crushed the pellets, this could take from 20min – 12 hours)
While the pellets are dissolving, get out a 3 to 5 CC
syringe, and draw up 2 – 3 CC's of oil and recap the
syringe and put it away. You will need this (2cc's) for one of the last steps in this process. (Note: get two cc's from the oil vial, darker solution, not the vial with the dissolving pellets, but from the unused oil vial)
Once the pellets are COMPLETELY dissolved, pour the oil from the vial you drew out 2cc's oil into the vial with now dissolved pellets. (Add oil from oil vial to dissolving pellets solution/pellets vial)
Swirl the oil/solution/dissolved pellets mixture for 5 – 15 minutes or until it is completely MIXED.
Get the now emptied oil vial (the one you used to pour oil into the pellet/solution vial) and place the funnel into it, then, place the opened coffee
filter into the funnel.
Then pour the oil/pellets/solution that has now mixed well, down into the coffee
filter slowly. Let it sit over night and drip into the vial.
In the morning. Gently squeeze out any remaining oil in the
filter and let it drip down the funnel. then remove the
filter and funnel.
This is a picture of the coffe
filter. discard all of the gunk the
filter caught.
Wipe top of the empty (so far unused, sterile vial) vial with alcohol, and insert a
needle tip to release pressure when adding the final product.
Use at least a ten CC
syringe and draw out 'oil/pellet/solution' mix into the
syringe.
Remove th
needle tip. Place a
filter and
needle tip on the filled
syringe, and
filter the
syringe contents into the sterile vial. Continue this step until all the 'mixed solution' is into the sterile vial.
Then, put the
filter on the
needle with the saved 2cc's (from the oil you saved earlier waiting for the pellets to dissolve) and insert the
needle in the sterile vial and run the oil through the
filter releasing any trapped 'product.'
Remove the
needle and
needle tip, and you now have 20ml of sterile ready to use Fina-Ject.
-willK
Note: i used a 50cc vial, so that is why the finished bottle looks so empty.
Note: you can skip the coffe
filter step, though i DONOT recomend it, as the finished product will be cloudy, and has clogged
needles.
I hope that helps some of you. If so, thank WillK, he wrote it!
Linear Mode
